SM400

Friskit Spray Mask is a latex saturated paper used for die-cut or hand-cut spray mask stencils and masking of surfaces to be painted. Used for sign lettering, auto pinstriping, and aircraft stenciling where paint is used instead of decals.

Adhesive is formulated to withstand temperatures of 200°F. to 300°F. for short periods of time. The product is designed to prevent paint from bleeding through and allows for a clean sharp edge. A liner allows product to be die-cut is desired. Can be adapted for computerized stencil machines.

EXTENDED OUTDOOR EXPOSURE IS NOT RECOMMENDED.

DO NOT USE ON COPPER, BRASS, OR ANODIZED ALUMINUM.

CONSTRUCTION

Face Film 3.0±.2 mils

Adhesive Re-adherable

Release Liner Optically clear photo grade polyester

PHYSICAL PROPERTIES

Backing Basis wt., lbs./3000 sq. ft.: 42 - 49 Thickness: 4 - 5 mils Tensile strength, lbs./in. M.D.: 12.7 Elongation, % M.D.: 6.0 min. Elmendorf tear, grams, M.D.: 56 min. C.D.: 56 min.

Adhesive Base: Natural Latex Adhesion to steel, oz./in. width: 24 - 30 (At time of manufacture) PSTC-1 (Modified)

Storage Shelf life 6 months if stored in a cool, dry place out of direct sunlight.

Sizes Width (INCHES) X Length (YARDS) *15 in. X 50 yds. 24 in. X 50 yds. *30 in. X 50 yds. 48 in. X 50 yds. * Available punched or unpunched.

The following information on physical and chemical characteristics is based upon tests believed to be reliable. The values are intended only as a source of information. They are given without guarantee and do not constitute a warranty. The purchaser should independently determine, prior to use, the suitability of this material for his/her specific purpose. (Data represents averages and is not intended for use as a specification.)