Scotchcal™ Electrocut™ Frosted Crystal 3.4 MIL • 3 YEAR
7725-300SE frosted colors by design resemble sand-blasted glass. Frosted crystal film has a clear permanent adhesive on a transparent synthetic release liner.
CONSTRUCTION
Face Film
3.4 mil
Adhesive Release
Clear, pressure sensitive
Release Liner
Transparent Synthetic
PHYSICAL PROPERTIES
Outdoor Durability
3 years when properly processed and applied (vertical exposure, unprinted film) 2 years in the U.S. desert southwest
Minimum Surface/Ambient Air Application Temperature
+40ºF. (4ºC)
Service Temperature Range
-20º F. to +175º F. (-29º C. to +80º C.) -Reasonable range of temperatures, which would be expected under normal environmental time and temperature conditions.
Typical Film Caliper (w/Adhesive)
.003 to .005 inch
Water resistance
Excellent water resistance
Chemical Resistance
Resists mild acids, alkalis, and salts
Shelf Life
2 years when stored in a clean, dry area, out of the direct sunlight, and at less that 100º F. (38º C)
Adhesion
Substrate
24 hrs.
Acrylic
4 lb/in. 0.7 kg/cm
NOTE: Always pretest your specific substrates prior to actual application.
Sizes
Width (INCHES)
X
Length (YARDS)
*15 in.
X
10 & 50 yds.
24 in.
X
10 & 50 yds.
*30 in.
X
10 & 50 yds.
48 in.
X
10 & 50 yds.
**60 in.
X
10 & 50 yds.
*
Available punched or unpunched.
**
DUSTED CRYSTAL & FROSTED CRYSTAL available in 60”
The following information on physical and chemical characteristics is based upon tests believed to be reliable. The values are intended only as a source of information. They are given without guarantee and do not constitute a warranty. The purchaser should independently determine, prior to use, the suitability of this material for his/her specific purpose. (Data represents averages and is not intended for use as a specification.)
GMI Series CV300
CONSTRUCTION
